Chevrolet Performance Connect & Cruise Kit - 350 HO Turn-Key Crate Engine w/ 4L65E Automatic Transmission

When it comes to factory-engineered performance and convenience, nothing beats Chevrolet Performance's industry exclusive Connect & Cruise 350HO & 4L65E crate engine kit from Scoggin Dickey Parts Center. With one package you get the engine, transmission, electronic controllers and all the necessary wiring, engine and automatic transmission controllers. Engine 350 HO Turn-Key Horsepower 333HP @ 5100RPM Torque 381FT/LBS @ 3700RPM Compression Ratio 9.0:1 Block Cast Iron 4-Bolt Main Caps, 1-Pc Rear Seal Crankshaft Nodular iron, 3.480" Heads Vortec Iron with 64cc Chambers Valves 1.94"/1.50" Camshaft Lift 0.435"/0.460" Hydraulic Flat Tappet Dur. @ 0.050" 212°/221° Components Engine 19433031 Transmission Install Kit 19420473 Transmission 19368611 Torque Converter 19299800 Transmission Controller 19332775 Chevrolet Performance engineers matched the engines and transmissions for optimal performance and durability, so you can wring out all the horsepower from them with total confidence. The specially calibrated controllers are designed for retrofit installation in older vehicles, for easier and quicker installation and operation, without the need for third-party tuning. Some Engine Controller Kits will vary with the small components that are included due to variations in engine applications. Most ECM and Wiring Kits contain the following items; Oxygen Sensors O2 Sensor Mounting Bosses Mass Air Flow Meter (MAF) MAF Mounting Kit Drive-By-Wire Throttle Pedal Assembly Oil Pressure Sensor and Harness (NOTE: Some crate engines have the the sensor installed from the factory) Complete Engine/ECM Wiring Harness with a Fuse Box Fuel Pump Power Module Fuel Pressure Sensor Kit GM Fully Calibrated ECM Detailed Instruction Sheet To properly install a Connect and Cruise engine kit, the installer will need to purchase or fabricate additional components to complete the installation. Some of the items you will need to prepare for are: Fuel Tank and Lines Fuel Pump - 58PSI for LS3, LS7 and 65PSI for LSA Front Accessory Drive Components Oil Pan Requirements Air Induction System Exhaust System NOTE: All components, engine, transmission, transmission installation kit, torque converter and controllers are ordered and delivered separately.