Chevrolet Performance Connect & Cruise Kit - L8P Crate Engine w/ 6L80E Automatic Transmission
When it comes to factory-engineered performance and convenience, nothing beats Chevrolet Performance's industry exclusive Connect & Cruise L8T w/ 6L80E kit from Scoggin Dickey Parts Center. With one package you get the engine, transmission, electronic controllers and all the necessary wiring, engine and automatic transmission controllers. With 523 Horsepower and 543 lb-ft of torque on tap, the L8P crate engine is the largest displacement and most powerful Naturally Aspirated Gen V LT family engine! Chevrolet Performance has optimized this care engine combining the displacement and strength of the L8T crate as a foundation for the power while adding a unique camshaft based on the LT2 found in the C8 Corvette Stingray! Engine Wet Sump L8P 6.6L Horsepower 523HP @ 5,800RPM Torque 543FT/LBS @ 4,600RPM Compression Ratio 10.8:1 Block L8T Cast Iron 6-Bolt 4.060" Bore Crankshaft Forged steel, 3.860" Stroke Heads 12736192 Cast Aluminum, 59.02cc Valves 2.130" Hollow Intake/1.590" Inconel Exhaust Camshaft Lift Hydraulic Roller 0.549"/0.549" Dur. @ 0.050" 218°/231° Components: Engine 19435523 Engine Controller 19435524 Transmission Install Kit 19432892 Transmission 19432682 or 19432684 Torque Converter Included with transmission Transmission Controller Included with transmission Chevrolet Performance engineers matched the engines and transmissions for optimal performance and durability, so you can wring out all the horsepower from them with total confidence. The specially calibrated controllers are designed for retrofit installation in older vehicles, for easier and quicker installation and operation, without the need for third-party tuning. Some Engine Controller Kits will vary with the small components that are included due to variations in engine applications. Most ECM and Wiring Kits contain the following items; Oxygen Sensors O2 Sensor Mounting Bosses Mass Air Flow Meter (MAF) MAF Mounting Kit Drive-By-Wire Throttle Pedal Assembly Oil Pressure Sensor and Harness (NOTE: Some crate engines have the the sensor installed from the factory) Complete Engine/ECM Wiring Harness with a Fuse Box Fuel Pump Power Module Fuel Pressure Sensor Kit GM Fully Calibrated ECM Detailed Instruction Sheet To properly install a Connect and Cruise engine kit, the installer will need to purchase or fabricate additional components to complete the installation. Some of the items you will need to prepare for are: Fuel Tank and Lines Fuel Pump - 58PSI for LS3, LS7 and 65PSI for LSA Front Accessory Drive Components Oil Pan Requirements Air Induction System Exhaust System NOTE: All components, engine, transmission, transmission installation kit, torque converter and controllers are ordered and delivered separately.
