Chevrolet Performance Connect & Cruise Kit - L8T Crate Engine w/ 6L80E Automatic Transmission
With 401 Horsepower and 464 lb-ft of torque on tap, the L8T crate engine is the largest displacement Gen V LT family engine in our lineup, offering plenty of low-rpm torque. Direct injection offers more precise fuel control than port injection, enabling a comparatively high compression ratio of 10.8:1 in the engine, which contributes to its high output. Engine Wet Sump L8T 6.6L Horsepower 401HP @ 5,200RPM Torque 464FT/LBS @ 4,000RPM Compression Ratio 10.8:1 Block L8T Cast Iron 6-Bolt 4.060" Bore Crankshaft Forged steel, 3.860" Stroke Heads 12703610 Cast Aluminum, 59.02cc Valves 2.130" Hollow Intake/1.590" Inconel Exhaust Camshaft Lift Hydraulic Roller 0.500"/0.492" Dur. @ 0.050" 193°/199° Components: Engine 19433748 Engine Controller 19433736 Transmission Install Kit 19432892 Transmission 19432682 or 19432684 Torque Converter Included with transmission Transmission Controller Included with transmission Chevrolet Performance engineers matched the engines and transmissions for optimal performance and durability, so you can wring out all the horsepower from them with total confidence. The specially calibrated controllers are designed for retrofit installation in older vehicles, for easier and quicker installation and operation, without the need for third-party tuning. Some Engine Controller Kits will vary with the small components that are included due to variations in engine applications. Most ECM and Wiring Kits contain the following items; Oxygen Sensors O2 Sensor Mounting Bosses Mass Air Flow Meter (MAF) MAF Mounting Kit Drive-By-Wire Throttle Pedal Assembly Oil Pressure Sensor and Harness (NOTE: Some crate engines have the the sensor installed from the factory) Complete Engine/ECM Wiring Harness with a Fuse Box Fuel Pump Power Module Fuel Pressure Sensor Kit GM Fully Calibrated ECM Detailed Instruction Sheet To properly install a Connect and Cruise engine kit, the installer will need to purchase or fabricate additional components to complete the installation. Some of the items you will need to prepare for are: Fuel Tank and Lines Fuel Pump - 58PSI for LS3, LS7 and 65PSI for LSA Front Accessory Drive Components Oil Pan Requirements Air Induction System Exhaust System NOTE: All components, engine, transmission, transmission installation kit, torque converter and controllers are ordered and delivered separately.
