Chevrolet Performance Connect & Cruise Kit - SP502/605 Deluxe w/ T56 Manual Transmission
When it comes to factory-engineered performance and convenience, nothing beats Chevrolet Performance's industry exclusive Connect & Cruise SP502/605 Deluxe w/T56 crate engine kit from Scoggin Dickey Parts Center. With one package you get the engine, transmission, electronic controllers and all the necessary wiring, engine and transmission controls. With the popular and proven ZZ502 as its starting point, Chevrolet Performance engineers took its capability to the next level to create the more powerful SP502/605 Deluxe, which is rated at a strong 605 hp and 580 lb-ft of torque. It's the sort of power for your vintage muscle car, hot rod or classic truck that comes only from the incomparable big block family. Engine SP502/605 Horsepower 605HP @ 6000RPM Torque 580FT/LBS @ 3800RPM Compression Ratio 10:1 nominal Block Cast iron with 4-bolt main caps Crankshaft Forged steel, 4.000"" Heads Aluminum oval port with 110cc chambers Valves 2.250""/1.880"" Camshaft Lift 0.649""/0.650"" Hydraulic Roller Dur. @ 0.050"" 246°/258° Components: Engine 19421299 Transmission Install Kit 19329901 Transmission 19352208 Chevrolet Performance engineers matched the engines and transmissions for optimal performance and durability, so you can wring out all the horsepower from them with total confidence. The specially calibrated controllers are designed for retrofit installation in older vehicles, for easier and quicker installation and operation, without the need for third-party tuning. Some Engine Controller Kits will vary with the small components that are included due to variations in engine applications. Most ECM and Wiring Kits contain the following items; • Oxygen Sensors • O2 Sensor Mounting Bosses • Mass Air Flow Meter (MAF) • MAF Mounting Kit • Drive-By-Wire Throttle Pedal Assembly • Oil Pressure Sensor and Harness (NOTE: Some crate engines have the the sensor installed from the factory) • Complete Engine/ECM Wiring Harness with a Fuse Box • Fuel Pump Power Module • Fuel Pressure Sensor Kit • GM Fully Calibrated ECM • Detailed Instruction Sheet To properly install a Connect and Cruise engine kit, the installer will need to purchase or fabricate additional components to complete the installation. Some of the items you will need to prepare for are: • Fuel Tank and Lines • Fuel Pump - 58PSI for LS3, LS7 and 65PSI for LSA • Front Accessory Drive Components • Oil Pan Requirements • Air Induction System • Exhaust System NOTE: All components, engine, transmission, transmission installation kit, torque converter and controllers are ordered and delivered separately.
