The Tuning School 5021 - GM LS and LT Standalone using Holley Terminator X Course

Are you ready to take control of your GM LS/LT build, while taking your knowledge to the next level of performance? Holley Terminator X training from The Tuning School is here to help. Learn how to properly install and set up your Terminator X and Max devices, while also learning a safe and repeatable process for tuning. Supported modifications for this course: heads/cam, bolt ons, and forced induction setups. Course Topics: -Basic Setup - Hardware -Sensors and Actuators -Software Operation -Software Setup -Datalogging Basics -Critical Parameters Setup -Tuning Topics (for N/A and Forced Induction combinations) -Fuel Injector Sizing -Engine Size -Idle/Part Throttle Tuning -Speedometer and Rear Gear Calibration -Engine Cooling Controls -Timing Table Updates -Fuel Table Updates -Airflow Table Updates -WOT Tuning -Drive by Wire Throttle Response -Working with the Learn Table -Target A/F Ratio -Transmission Tuning Supported Engines: LS1/LS6, LS2/LS3, LS 24X 4.8/5.3/6.0 Trucks, LS 58X 4.8/5.3/6.0 Trucks, and Gen V LT applications. Supported Transmissions: 4L60E and 4L80E (LS Specific) and 4L60 and 4L80 (LT Specific)